drains

Our new shed and improved drainage

Posted on Updated on

IMG_7548

The big news for us at the farm is the completion of our new ‘American barn’ style shed … which will finally allow us to get a tractor!

The new driveway to the shed is designed to shed the rain off one edge, to prevent the shed from flooding. While this is a good design, the first heavy rain we had immediately started eroding the 45 degree earth slope beside the shed.

So I spent a weekend creating a “rubble drain” to ensure that water doesn’t cause any more damage.

IMG_7535
The hand-dug trench, up the steep slope towards the driveway

The starting point was digging a trench that followed the line of erosion. This was lined with weed mat, and then filled will rocks that I lugged up the hill by hand. (A wheelbarrow’s no use on a 45deg slope!)

IMG_7541
The rubble-filled trench, looking up the 45deg slope

The first part of the trench also has a slotted ag pipe, to ensure good water flow, all of which is hidden by the layer of rocks.

IMG_7537
The top of the trench, beside the driveway, with the slotted ag pipe, and half-filled with rocks

It’s a great way to get fit (ha!), and the result is rather lovely I think. Tick that job off!

A different approach to grey water

Posted on

I’m now four weeks into the part-time Winter Permaculture Design Certificate course being run in Sydney by Milkwood Permaculture. In addition to the course material itself, Nick and Kristen bring along a great library of books to browse through during the breaks.

One that caught my eye was Create an Oasis with Grey Water by Art Ludwig.This is perfectly timed, as we’re half way through the design process for our house extension, and grey water was definitely on the list.

“Standard” grey water systems

I’d been looking into “standard” approaches to grey water, and wasn’t very impressed.

The basic design is to connect up the washing machine to a small-ish under-floor holding tank. A pump then extracts the water and sends it out to drip feeds throughout the garden. Health department regulations prevent the water from being held for more than 24 hours, adding complexity to the system. With tanks and pumps, there needs to be filters, maintenance and careful use.

These systems also aren’t cheap. Having a casual chat to my friendly water tank folks, they quoted a figure of $3000-4000 for an installed system, including all the extra plumbing.

The biggest issue is their limited use. Standard approaches involve connecting up perhaps just one appliance to the system:

  • Washing machine: yes, assuming that suitable washing powders are used.
  • Hand basins: yes, but why bother, doesn’t produce much water.
  • Shower: NO, produces too much water, would overwhelm the drip feeds.
  • Dishwasher: NO, too much solid matter.
  • Kitchen sink: NO, too much solid matter.

So that’s $4000 for a system that diverts perhaps 200L of washing machine water into the garden once a week. Hardly seems worth the effort!

Branched drains

The grey water book listed earlier outlines a very different approach. The big advantage we have is that our back garden has a fairly substantial slope, meaning that gravity can do all the work.

This allows the installation of a “branched drain” approach, work works as follows:

  • All relevant grey water sources (washing machine, dishwasher, shower, sinks) are piped to a single location under the house.
  • The water enters into a gravity-fed system of 1-1.5″ pipes which head into the garden. (The pipes self-clean, preventing any blockages from solid matter.)
  • The water is carefully split into as many feeds as required.
  • Instead of using drip feeds (which block and only support low flows), the water is directed into mulch-filled basins.
  • These basins feed trees, which can soak up a lot of moisture.
  • The rest is absorbed into the ground, for the benefit of the rest of the garden over time.

The big benefit of this approach is its simplicity. From what I’ve read, it takes a lot of careful up-front design, but after installation it runs itself. No pumps, filters or maintenance. It will cope with large volumes of water, even when the ground is already wet.

The starting point for the design is to work out two things:

  • grey water produced by the house
  • “perk value” of the soil (how quickly water is absorbed)

I’ll work these out over the next few weeks, and will blog the results. Then I’ll start liaising with the plumber and architect to work out how to factor it into the building designs.

In the meantime, the Laundry to Landscape© Grey Water System page outlines a simple approach that can be taken by almost anyone to make use of the washing machine water with little or no effort or cost.